Multiboot (DuckBA) for Spark 7162 and 7111

1 IMPORTANT

a Microsoft DotNet Framework 4.0 is required. 
b. Partitioned and formatted USB flash drive is required. 
c. The configuration of multiboot is possible, but only from E2/Neutrino. It does not work out of Spark. 
d Mulitboot Since version 0.8 also works with USB-connected hard drive port. 

2 configuration:

a start program. 
b. Press on the "configuration" (Configuration). 
c. Select "Amiko Alien." (For all Spark 7111-boxes) or "Spark 7162" in the drop down list 
d Set the IP address.  e Set password. 
f Save Settings 
g End Program



3 Image instalation: 

a."Extract Image partition on" (Extract image on partition) Select. 
b. Select the USB drive from the drop-down list. 
c. The partition table should be filled in automatically if the partitioning  Check the USB flash drive (see 1.b) 
d set for the partition to be used, as follows:  i - the name (label)  ii. - Than EXT2 file system 
e Verify that the option "Format the partition always unpack before the image"  (Always format partition before extracting image) is activated. 
f "Image Extract" (Extract image) select.

4. Mulitboot Configuration:

a "multi-boot manage" select (manage multiboot) 
b. "Read" (Read) Select. 
c. If the program detects that runs a Spark Image, the configuration  Options are disabled. 
d To add a new position to multiboot set, the name in a field near  the partition number and press "add" (add). 
e In order to activate the image of a given partition, "Enable Image" (Activate image)  and then select start the box again. 
f If the image does not boot from USB, it could not be properly extracted.


yo no tengo un deco de estos pero me gustaria saber si alguien lo pone a funcionar que tal va

yo en los vu tengo la Blackhole y 5 o 6 backups distintos en el usb y juego con las images  y la verdad es una gozada

[archivo adjunto borrado por el administrador]