Updating firmware via DreamUpHow do I play with new software DreamUp on the Dreambox DM 800 HD se:
Dreambox 800 HD se and service connection:
If you use the service port (to update the operating software)
would like to work, you must first install the following drivers:
VCP Drivers - (USB to UART Bridge Virtual COM Port (VCP) driver)
Crossover cable and USB Type A - Mini USB type B:
DreamUP version 1.3.3.7:
Home / 2 All Receiver - DVB modules and S - C - T / 3 Dreambox / Progs - Tools - Flasher / Flash Software
First disconnect the box from main power
start the program "DreamUp"
Unplug the Dreambox is the first network
Start the program "DreamUp
select: comport 1 or 2
use network
if network: enter the local IP from your PC, enter a remote IP for your box
Please select the Com port to which the Dreambox is connected
Selection: Network / without network
when network: Enter Local IP of the PC, enter a foreign IP for the box
press the "Connect" - button
and then connect the box to main power
please wait now
the "Connect" button click
and then connect the box to the power plug
Please wait while now
after the flash loader is Transferred into the box select the firmware by pressing
The "Flash" - button
after the flash loader is transferred to the box, select the
Button "box flashing" the operating software from
select the firmware and click "open"
Select the firmware and click "open "
upload starts now, please wait
The upload is started, please wait
Box is flashing the new firmware into the flash memory, please wait
Box copies the new firmware into the flash memory, please wait
flashing done, press "OK"
press "disconnect then exit"
restart the box
"The box was flashed successfully, " click on "OK"
click disconnect then exit "
Box restart
Gracias al autor