1 IMPORTANTa Microsoft DotNet Framework 4.0 is required.
b. Partitioned and formatted USB flash drive is required.
c. The configuration of multiboot is possible, but only from E2/Neutrino. It does not work out of Spark.
d Mulitboot Since version 0.8 also works with USB-connected hard drive port.
2 configuration: a start program.
b. Press on the "configuration" (Configuration).
c. Select "Amiko Alien." (For all Spark 7111-boxes) or "Spark 7162" in the drop down list
d Set the IP address. e Set password.
f Save Settings
g End Program
3 Image instalation:
a."Extract Image partition on" (Extract image on partition) Select.
b. Select the USB drive from the drop-down list.
c. The partition table should be filled in automatically if the partitioning Check the USB flash drive (see 1.b)
d set for the partition to be used, as follows: i - the name (label) ii. - Than EXT2 file system
e Verify that the option "Format the partition always unpack before the image" (Always format partition before extracting image) is activated.
f "Image Extract" (Extract image) select.
4. Mulitboot Configuration: a "multi-boot manage" select (manage multiboot)
b. "Read" (Read) Select.
c. If the program detects that runs a Spark Image, the configuration Options are disabled.
d To add a new position to multiboot set, the name in a field near the partition number and press "add" (add).
e In order to activate the image of a given partition, "Enable Image" (Activate image) and then select start the box again.
f If the image does not boot from USB, it could not be properly extracted.
yo no tengo un deco de estos pero me gustaria saber si alguien lo pone a funcionar que tal va
yo en los vu tengo la Blackhole y 5 o 6 backups distintos en el usb y juego con las images y la verdad es una gozada[archivo adjunto borrado por el administrador]