Autor Tema: New official image for TGS 100 rel 2.0.17 (Leído 3571 veces)

Perfil · Registrado: 17/01/2008 Gracias: 144/3190 Mensajes 20498

New official image for TGS 100 rel 2.0.17

How to do auto-update with ITGATE Control Center
New Control center must be used from now on.(from ver.2.4)
1) Download and Unzip the file below.
2) Run the ITGATE Control Center.
3) Insert & save IP address in the 'Config' section.
4) Press 'Update' button & select the *.img file in the 'Update' section.
5) Autoupdate will be started.
6) Wait until the receiver reboots automatically

How to update TGS100 with Memory Card automatically
1) Copy all below files(after unzip) inside folder to the memory card.
2) Switch off TGS 110 and insert the memory card into the memory 
   card slot of front panel.
3) Switch on TGS 110 and you can see "doun" on LED display,
   it means downloading is started.
4) Soon after, you can see downloading process by number
   (1~100) on LED display. Please wait until it shows "done".
5) After checking "done" on LED display, remove Memory Card 
   and switch off and on again.
6) Update completed!
Warning) Do not remove memory card during reading 
and writing mermory card in any cases.

How to update TGS 100 by Flashing through serial port
New Control center must be used from now on.(from ver.2.4)
1) For Serial update, please click to download the image.
1. Connect the receiver & PC with RS 232 cable
2. Power on the receiver & press up button on the front at 
   the same time repeatedly.
3. You will see the menu,in which there is 'Serial Update' & 
   go to the menu using by up/down button.
4. When you cursor located on 'Serial update', press right button
   & Press ok button to start the upgrade.
-----------------------------------------------------
Before the above no.4,
1. run the control centre & go to the 'Serial update' section 
   (you don't need to input IP address)
2. After setup the com port, press 'file' & select the img.file.
After that, you can start the serial update under the above no.4

How to update by Internet
1) Press MENU button on the remote controller and go into " Setup -> Expert 
    Setup -> Software Update -> Internet Update" and select the image.
2) Follow as prompted on the menu..

Improvements are:
- Fixed 'hang up' on zapping channels
- Fixed 'Fan control'
- Fixed 'rebooting' on web interface
- Added EPG search menu
- Improved Plugin API
- Improved Teletext
- Added standby mode in hdd setup menu
- updated libcrypto.so.0.9.7
- Added 'Retrieve Internet IP' in menu

TGS100_autowin_rel2017.zip

TGS100_automc_rel2017.zip

TGS110_srl_rel2017.zip