SETTING UP CCCAM ON SRT4669Z
If you are using a router/switch etc., get LAN/rj45 network cable
The connect network cable between router/switch(internet source) and decoder
Press menu on remote controller
Select system setting
Then, select ipsetting
Dhcp usage is automatically set to ON
Eg.
DHCP Usage - ON
IP Address - 0.0.0.0
Subnetmask - 255.0.0.0
Gateway - 0.0.0.0
DNS - 192.168.1.1
MAC Address - ********** don’t change mac address
Press red buttom(recall) on remote for SCAN
System will automatically assign ip address, new subnetmask, gateway address, dns server address, after maybe 20seconds. Press exit to go back. Press ok on remote to enter ipsettings again. You will see something similar to example below:
Eg.
DHCP Usage - ON
IP Address - 192.168.1.93
Subnetmask - 255.255.255.0
Gateway - 192.168.1.1
DNS - 192.168.1.1
MAC Address - ********** don’t change mac address
Now decoder is connected to internet, and has internet access. The rest below will follow. Good luck
with srt4669z,will need a small firmware for account configuration,so that 8281 can work with his decoder。
8281 is a key you press on remote to get cccam/newcamd account setting menu
HOW TO UPDATE THE FIRMWARE TO THE STRONG BOX?
to upgrade firmware to strong box
download firmware to usd disk
then insert usb disk/stick to decoder
Now After Inserting, Follow:
1. press menu in remote
2. click on storage
3. then file manager
4. the select the file: "module002p.stb"
5. wait for writing on decoder to finish
6. write successful
7. decoder will reboot
8. now press 8281 in remote to get menu for cccam/newcamd account
You will see:
Server - Protocol - Active - Status
1. first line: line 1(Connection_0) in account menu
2. press ok on remote
3. change protocol from newcamd to cccam
4. timeout - don’t change
5. filtermode - don’t change
6. filterlist - don’t change
7. ID - put id from supplier (eg. Ten103)
8. Password - put password from supplier (eg. kiws)
9. Address - put server address from supplier. (eg: linuxdvb.no-ip.org)
10. Port - put port number from supplier. (eg. 22333)
Then,
1. press exit on remote
2. select yes to save settings
3. press red buttom on remote to connect to cccam server (under “active” will turn from off to on)
4. STATUS will now show "OK [1.98kb]" etc
5. then you know cccam is working
6. press exit buttom to exit account configuration area
Then,
select supersport1
because it opens faster
if you see picture and hear sound, then
wait for about five minutes and check other channels
Good luck!!!
[archivo adjunto borrado por el administrador]