USB2Serial FTDI & PL2303 Kernel Module
Connect to you Box with FTP.
Load the .ko Files to e.g. /tmp (/tmp will be resettet after poweroff or reboot!).
Then connect with Telnet to you Box and type these two commands:
insmod /tmp/usbserial.ko
insmod /tmp/ftdi_sio.ko (if you have a FTDI based device)
insmod /tmp/pl2303.ko (if you have a PL2303 based device)
Put now your USB2Serial converter into usb and type
dmesg
was you device recognized?
This should look like:
code:
usbcore: registered new driver usbserial
drivers/usb/serial/usb-serial.c: USB Serial Driver core
drivers/usb/serial/usb-serial.c: USB Serial support registered for FTDI USB Serial Device
drivers/usb/serial/usb-serial.c: descriptor matches
drivers/usb/serial/usb-serial.c: found bulk in on endpoint 0
drivers/usb/serial/usb-serial.c: found bulk out on endpoint 1
ftdi_sio 1-1:1.0: FTDI USB Serial Device converter detected
drivers/usb/serial/usb-serial.c: get_free_serial 1
drivers/usb/serial/usb-serial.c: get_free_serial - minor base = 0
drivers/usb/serial/usb-serial.c: usb_serial_probe - setting up 1 port structures for this device
drivers/usb/serial/ftdi_sio.c :D etected FT232BM
drivers/usb/serial/usb-serial.c: usb_serial_probe - registering ttyUSB0
usb 1-1: FTDI USB Serial Device converter now attached to ttyUSB0
usbcore: registered new driver ftdi_sio
drivers/usb/serial/ftdi_sio.c: v1.4.3:USB FTDI Serial Converters Driver
Smargo Reader also should work (with FTDI module)!
[archivo adjunto borrado por el administrador]